BASERACK WIRING KIT NO WIRES

BASE Rack Wiring

Traditionally wiring for accessories fitted to roof racks has involved wiring going up windscreens, up out of B pillar door gaps and the like. As part of the ARB BASE Rack development ARB's engineers have developed a wiring solution to neatly get wiring from inside the vehicle through the vehicle or canopy roof.

Two wiring kits have been developed. One kit is pre-wired with 6 wires (3 circuits) preinstalled to ensure sealed wiring. (1780400) The second kit has provision for 6 wires allowing differing wiring depending on customer requirements. (1780410)

Key criteria during development included:

• \t
• Sealed wiring solution for passing wires through a vehicle roof\t
• Seamless integration with ARB BASE Rack\t
• Exit grommets to fit standard 10mm (3\/8ÔÇ?) and 13mm (1\/2ÔÇ?) OD conduit sizes\t
• High quality automotive wire to JASO standards (PN 1780400 only)\t
• Free from liquid adhesives\t
• Disconnection kit to reseal roof exit points when rack is removed (PN 1780620)

Fitting of the wiring kits requires 2 x 7mm (0.28ÔÇ?) and 1 x 25mm (1.0ÔÇ?) holes to be drilled in the vehicle or canopy roof. The 25mm hole is suitable for Deutsch DT-02 connectors to pass through. Mount location for popular vehicles has been developed allowing for side curtain airbags and other obstructions where necessary.

The 1780410 kit includes:

• \t
• • Rubber outer boot with 300mm sheath\t
• BASE Rack entry grommet\t
• BASE Rack exit grommet\t
• Direct exit grommet\t
• Fasteners\t
• Cable ties and edge clips\t
• Two seal types have been developed to suit different customer wiring requirements.\t
  • \t\t
  • Type 1 supports up to 6 x 2.2-3.2mm (0.087-0.125ÔÇ?) wires\t\t
  • Type 2 supports up to 2 x 2.2-3.2mm (0.087-0.125ÔÇ?) plus 2 x 3.9-5.8mm (0.154-0.228ÔÇ?) wires\t
  \t